EcoStarter: GSM Fixi   [en]
Please note that after 8 years of activity
EcoStarter has stopped selling GSM-based
remote control equipment.
The company takes over this activity.

GSM Fixi Plus
SMS and Internet-operated Switch Control

A simple and robust solution
for fixed installation in fuse box

Fourth generation:


Your advantages:

Operating voltage: 230V 50Hz or 12-15V DC. Max load per output: 16A 230V. Built-in outputs (relays): 2. Consumption: 0.4 W (standby). Operating temp.: –20 to 50°C. Temp. sensing: –29 to +49°C.
HxLxD: 70x90x58mm. Weight: 375g. GSM: Dualband 900/1800 MHz.
Complies with the European R&TTE directive. GSM Fixi is designed for indoor use only.
Send commands to GSM Fixi to remotely switch on or off the appliances connected to its 2 outputs: heating, hot water, lights, pumps, small servers, wall sockets, etc.

  • Remote control of 2 outputs (16A relays) and 2 temperature sensors.
  • Thermostat function where the desired temperature (set point) may be set by SMS.
  • Timer control.
  • Temperature surveillance: you receive an SMS if it gets colder or warmer than you want.
  • Digital NO/NC input for relaying alarms by SMS.
  • Power outage alarms (a battery is built-in).
  • Personal access code for protection.
  • Usable either in 12V DC or in 230V/50Hz environments for:
    • low-voltage control of electronic circuits, or
    • 230V control of loads of up to 2*3600W (only for fuse box installation by qualified technicians).
  • Installation as DIN module.

Included: a GSM antenna (with 2 meter cable) and a temperature sensor (with 8 meter cable). A SIM card is built-in for the Internet connection. Simply insert your own SIM card to enable control by SMS messages.

Free option: forwarding of alarms to your e-mail.

GSM Fixi requires a valid SIM card from a mobile phone operator.